Jump to content

vniow

vniow

Member Since 24 Jul 2005
Offline Last Active Nov 09 2011 03:02 AM
-----

Topics I've Started

What am I doing wrong?

29 January 2007 - 08:49 PM

I've been trying to get the latest Jas release on my system for the past four days but nothing has worked. My system is pretty similar to the $200 Mac posted here awhile back, the relevant parts are an Asrock P4 Dual 915GL and two hard drives, a 200GB PATA I'm using for backup and a 100GB SATA I'm trying to use for the OS. Ideally I would like to have Either only OSx86 or dual boot that and Ubuntu but I can't figure out why its not installing properly.

I checked the HCL and SATA is supposed to work fine for this MB but its not installing. When I try to dual boot using one of the guides on the wiki I can't get Disk Utility to erase the relevant partition. I can however erase the entire disk and install on it but it doesn't boot afterwards, just goes to a blank screen with a little blinking cursor on top.

I'm using the lastest patches including the Disk Utility one and I had 10.4.8 installed on this before (on the SATA drive I believe) and it was working fine, I just don't know what the problem is.

Thanx,

-Ani

internet lost in 10.4.5

25 March 2006 - 11:05 PM

Hi, after doing a clean install to 10.4.5 from the Myzr iso and while ethernet seems to work, internet doesn't. It detects the card fine but its not quite talking to it correctly. I'm using the Asrock P4915dual 478 which has given me no problems before. I tried swaping out the IOnetworkingfamily.kext from a 10.4.3 disc and repairing permisions but it didn't seem to work. Anyone else have any other suggestions?

Even with no internet its nice that it finally shuts down properly now. :)
© 2017 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy