Jump to content

MegaEduX

MegaEduX

Member Since 26 Oct 2009
Offline Last Active Aug 27 2010 04:04 PM
-----

Topics I've Started

[SOLVED] P5KPL-AM (rtl8192e) strange problem

25 August 2010 - 04:57 PM

Hello,

I just hackintoshed my server, which has a P5KPL-AM motherboard, but am facing a strange problem with my LAN adapter, which is an onboard RTL8192E.

I tried to install some drivers, like the R1000 kext and the Realtek official one, but when I go to Networking, under System Preferences, it always shows that it is connected under a self-acquired IP, EVEN IF THE CABLE IS PLUGGED OFF.
I've been all day researching and trying drivers and couldn't find any solution.

Any ideas?

SOLVED. It seems the drivers I was trying to use weren't compatible with a 64-bit kernel. Booting with a 32-bit kernel done the trick.

OSX HomeServer

23 August 2010 - 01:57 AM

Hello,

I am a OSX User (like, Macbook :P) and am now focused in trying to get my homeserver to work with OSX Server. I don't mind replacing some (or most... or all, heh) of its hardware with OSX-friendly one. I'd appreciate someone gave me some advice on that.

Motherboard: ASUS P5KPL-AM
Processor: Intel Pentium Dual E2200 @ 2.20 GHz
RAM: 3GB DDR2
Hard Drives: 1x 500GB, 2x 320GB SATA.
Graphics Card: Integrated. I heard I may need to have a dedicated graphics card to install OSX, but as I'm not 100% sure about that and don't remember where I read that, I'd like to hear someone else's opinion if it's needed.

Thanks in advance,
Eduardo.

Help with 10.6 on P5KPL-AM (Won't start installation, ACPI error)

14 December 2009 - 10:16 AM

Hello,

I am trying to hackintosh my computer with a Intel Pentium Dual CPU E2200 @ 2.20GHz, 3GB of RAM, and a P5KPL-AM (with integrated graphics).

Followed the old lifehacker guide (http://lifehacker.co...start-to-finish) as the new one gave me a monitor sync problem.

I boot into chamaleon perfectly from USB stick, press tab, boot into my USB stick with -v flag and it hangs at:

ACPI: System State [S0, S3, S4, S5] (S3)

Tried to replace the kexts with a kext pack from 10.5.6 (can't remember where I got it, damn.) and it still errors at the exact same place.

Would appretiate some help :(

Thanks,
Eduardo.
© 2014 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Mac Netbook  |   PHP hosting by CatN  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy