Z0ID

Hey Steven

May i have the needed kexts but no guarantee... would be easier if u post the hardware ID`s...
I use 10.6.8 may u have to upgrade may it will not work at all

If you dont see networks turn off Wifi via OS and then Press the Hardware key several times (FN+F3 for me)
and then turn it on again it should work

g00d luck

Where is the Problem everything runs fine except of QE/CI & Cardreader ?
Use a retail installation & Chameleon on USB
When upgrading to 10.6.8 you have to use a patched kernel with Atom support..

iAtkos is for idiots...

Hey just saw your post

Last week I made it working after some unsuccessful attempts and large amounts of coffee... xD

1) Use GPT Partition Layout

2) I use 4 Partitions:
1. EFI Partition (u CAN use it for chameleon)
2. TeutonPE (based on WindowsXP) (NTFS) Installed via Thumbdrive
3. OSX 10.6.8 (HFS) Installed via Thumbdrive
4. Debian Squeeze (Ext4) Installed via Thumbdrive prepared via Unetbootin

3) First install Windows
(create and resync HybridMBR after every reboot during this installation)
I used a thumbdrive with gParted debian distro, run Terminal / and use gDisk
It also works via rEFIt but it was unsuccesfull for me...
BTW: dont forget to use NLite to slipstream the SATA Drivers into the windows Setup Medium...

4) then OSX and Chameleon ( I use Meklort`s modified Bootloader to have 1024x600 resolution with GMA 3150)

5) then boot the debian installation thumbdrive but only Format the last drive and install Grub on it ( /dev/sda4 in my case & not in the main Partition !!!) dont install now just reboot and

6) Again boot gParted from Thumbdrive and again run gDisk resync the HybridMBR on the Windows Partition

7) Now you can Boot again the debian Setup and install the system but without Formatting the drive before means leave the filesystem completely untouched. Debian warns you that you dont have a clean drive to install on, {censored} on it

Sounds crazy I know but i was succesfull at the end, Chameleon recognizes and boots all three systems

g00d luck