Jump to content



Member Since 20 Jul 2008
Offline Last Active May 27 2009 12:45 PM

Topics I've Started

TP-Link Network interface

13 September 2008 - 02:42 AM

Can someone tell how to get the interface back on this usb device. I had to re-install the os and the driver for the TL-wn321g. When I did the network prompted me to add the en3 interface and I mistakenly canceled it and after multiple installs of the driver, it never prompts me to add the interface again. Is there a way to manually add it? The usb utility works fine and I can see and connect to the access points, however there is no network interface.

Any help would be greatly appreciated.

Network Problem

25 July 2008 - 12:47 PM

I'm having a problem connecting to my home network. I have a hub connected to a DSL modem. The modem is setup for DHCP and works fine for my windows devices in issuing an IP address. I've setup eth0 to use DHCP and it says that the cable is unplugged and will not connect. I then used the static method and set the IP address to an unused ip and that seem to have worked for a short time and then stopped. I have no problems with connecting to a network with a domain controller that uses DHCP,DNS and WINS.

Has anyone seen this before?
© 2017 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy