Jump to content



Member Since 13 May 2008
Offline Last Active Feb 12 2017 01:38 AM

Topics I've Started

Nvidia 9300GE osx 10.8

06 May 2015 - 05:23 PM

Ok, so I'm not new to hackintoshing, I've built 4 or 5, but this one has got me a little stumped. I've installed 10.8, and everything works except for the graphics. After booting I get the "no signal" message on my monitor. I've had this before with other cards, those were solved with an EFI string in the boot.plist. Not so with this one.


It will boot however if I use the flag nv_disable=1 Then its fine, minus acceleration. I've done much seaching, and after finding this thread, think I'm getting close



However the modified kext file he linked to is gone :(



So, does anyone know how he might have modified the NVN50Hal.kext? I assume he probably put in a device ID somwhere, but this is where my knowledge fails me as I've not had to do that before.....



So, any ideas\help woyuld be greatly appreciated.

© 2017 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy