Jump to content

meltman

meltman

Member Since 06 Feb 2008
Offline Last Active Nov 16 2013 07:36 PM
-----

Posts I've Made

In Topic: Melt's G5 mods - one complete, one in progress

02 March 2012 - 05:38 PM

Would you by chance have a step by step guide on how to make that? I would really like to.

EDIT: The jumper that is.


Step1: Get a power cord
Step2: Cut power cord with scissors to the desired length
Step3: Solder the 3 wires from the cut power cord to the IEC socket receptacle you bought.
Step4: Plug your jumper cord into your power supply inside the case

In Topic: Melt's G5 mods - one complete, one in progress

01 March 2012 - 04:20 PM

Although I too am interested in purchasing your case (I cant' offer a price at the moment because I may be able to get my hands on a case in the near future), I have a different question. How did you setup your PSU so that you could plug it in through the rear port? I looks really clean!


I cut a power cord so there is a short "jumper" that plugs into the power supply.


This looks very clean. good job. I also would like to know how you ended up moutning your PSU to the top? Also how did you end up mounting the Mountain Mod Mobo tray to the case? Did you use J/b weld or something?


The short stock standoffs are

perfect

height to hold up the motherboard tray! I popped the long ones out with pliers. I used the stock motherboard screws to bolt the mountain mods tray to the stock short standoffs in the case.





My case uses NO glue or epoxy or any other "ductape mods".

In Topic: Melt's G5 mods - one complete, one in progress

22 February 2012 - 03:02 PM

How much would you pay for one? I'd consider selling the mountain mods one in this thread for the right price.

In Topic: Melt's G5 mods - one complete, one in progress

04 November 2011 - 03:19 PM

One more thing, where did you get the motherboard header connectors from ?

I've searched for them but can't find anything yet ...



I had an old case that I cut them off of.

In Topic: Melt's G5 mods - one complete, one in progress

01 November 2011 - 01:01 PM

Ahh right, the one I'm buying will be complete as well, so I'll mock something up. How did you do the audio connectors as I've heard the 'on connect' is inverted by ATX standards ?

Could I be really needy and ask for the pin outs you used as well ?

Thanks,

Nick


I'll have a look on ebay for some nice sleeving and heat wrap


FPAudio does not work because of the sense issue. I dont really care though because I never use that port.
Here's the diagram pack I used: Link
© 2014 InsanelyMac  |   News  |   Forum  |   Downloads  |   OSx86 Wiki  |   Mac Netbook  |   PHP hosting by CatN  |   Designed by Ed Gain  |   Logo by irfan  |   Privacy Policy