slimvaio Posted February 3, 2008 Share Posted February 3, 2008 Hi I have burned the KALYWAY 10.5.1 DVD and when it goes to boot I get this message By slimvaio, shot with NIKON D200 at 2008-02-02 I type in -v and hit enter and then it goes to this screen By slimvaio, shot with NIKON D200 at 2008-02-02 After that it just goes back to the first screen Please help if you can. Thanks And here is what I am running in the machine Install DVD = KALYWAY_LEO_10.5.1intel_SSE2_SSE3 ABIT IP35 Pro LGA 775 Intel P35 ATX Intel Motherboard EVGA 512-P3-N801-AR GeForce 8800GT 512MB 256-bit GDDR3 OC@4.2 Intel Core 2 Duo E8400 Wolfdale 3.0GHz LGA 775 Patriot Extreme Performance 8GB(4 x 2GB) 240-Pin DDR2 SDRAM DDR2 800 Western Digital Caviar SE WD1600AAJS 160GB 7200 RPM SATA 3.0Gb/s 4x Western Digital Caviar SE16 WD7500AAKS 750GB 7200 RPM SATA 3.0Gb/s SAMSUNG 20X DVD±R DVD Burner with LightScribe Black SATA Model LIAN LI PC-A05B Black Aluminum ATX Mid Tower Computer Case Link to comment Share on other sites More sharing options...
westwaerts Posted February 3, 2008 Share Posted February 3, 2008 as far as i see, everything is ok from the install disk you need not boot in verbose mode -v just run it with no options, hit enter and after quite a while you should see an installer setup window ( can take up to 10 min ) Link to comment Share on other sites More sharing options...
Harloe Posted February 3, 2008 Share Posted February 3, 2008 Hey slimvaio, I don't wanna sound like a moderator but just telling you that this thread would be better off in this area of the forum: http://forum.insanelymac.com/index.php?showforum=136 You'd most probably get a lot more help there to! Good luck! Link to comment Share on other sites More sharing options...
slimvaio Posted February 3, 2008 Author Share Posted February 3, 2008 Thanks for the advice in posting it else where I will. And I did try to push enter and it goes right back to the first screen. Any other suggestions? Link to comment Share on other sites More sharing options...
Recommended Posts