Jump to content

Boot loader problem


1 post in this topic

Recommended Posts

Hey all,

After my sucessful instalation of OSX 10.7 in vmware, I rebooted my computer and I got a chain0 error. It took me around 3 hours to install and I figured out that I needed to install OSX on a primary partition. My bad!

 

However, I'm currently re-installing it on a old test hardrive (wich is very slow in vmware by the way). I do this because my hardware is not supported (install cannot detect my disc so I'm having a "still waiting for root device"). Anyway, now I'm pretty sure that'll work but I just wanted to know :

 

If I install OSX in the H: drive using the entire disk, where do I put the chain0 file and what command line do I put in the boot.ini? My main disk is C:.

 

I use the default method?

 

Thanks

Michael

Link to comment
Share on other sites

 Share

×
×
  • Create New...