deathklok Posted February 14, 2018 Share Posted February 14, 2018 Hey everyone, I'm having a strange and seemingly rare issue with my High Sierra installation. My computer is an HP EliteDesk 800 G1 / i7-4770 / Intel HD4600. Whenever I boot, I always get a green screen after the Clover boot loader. However, if I wait until the computer enters sleep mode (not just the screen, the actual PC) and wake it up, the screen displays everything just fine. My installation was super quick and easy: Installed High Sierra on an SSD connected to a hard drive dock using my MacBook Pro Booted into that installation using my MacBook Pro and installed Clover Replaced the EFI folder on the EFI partition with one I found online for the HP EliteDesk 800 G1 (I believe it was posted by Donw35) Installed the drive on my HP EliteDesk 800 G1, booted and that's it I can confirm that everything is working fine, except on-board audio which I don't need since I'm using a USB interface. There are no graphical issues otherwise (doesn't hang, visiting www.clover.com on Safari, like stated above, works fine). Does anyone have any idea what might be causing this? It's very annoying having to wait 2 or 3 minutes every time I boot just so I can wake the computer and get a picture. Thank you in advance! Link to comment Share on other sites More sharing options...
Allan Posted February 14, 2018 Share Posted February 14, 2018 Use this guide:[Guide] Sierra / High Sierra on Intel 5, 6, 7, 8, 9 and x99 Chipset Series / Nehalem, SandyBridge, IvyBridge, Haswell, Broadwell 1 Link to comment Share on other sites More sharing options...
Donw35 Posted February 23, 2018 Share Posted February 23, 2018 that sounds strange, for the record I am using the same machine but with a Nvidia GT 1030 and an i5 processor Link to comment Share on other sites More sharing options...
Razzor007 Posted March 24, 2019 Share Posted March 24, 2019 Hi I have a similar problem with my Hp elite desk 800 g1 , I use a dedicated GPU Rx 560 and my problem is with the dvi port I can't boot with a monitor plugged in to it , if I do after apple logo the screen turns black , also if I boot just using the HDMI connector it works but if I plug the dvi too both screens turn black , the only way I can make the dvi work is to boot with the hdmi then put the pc to sleep after I wake it I can plug in the dvi and it works together with the hdmi . Using or not lilu and whatevergreen makes no difference . Sorry for my bad English . Link to comment Share on other sites More sharing options...
Recommended Posts