TheChosenTaco Posted May 28, 2017 Share Posted May 28, 2017 Good day everyone, so I have followed multiple tutorials instructions to setup my USB stick to install sierra on my PC, all my hardware is compatible as I have checked online and all my bios settings are set to what the tutorials specified, but I seem to have run into a problem. Whenever I boot from clover into the installer, without verbose I just see the apple logo then it disappears and my PC restarts. In verbose, I see the first 2 lines and then a bunch of +++++'s for a full line and then it restarts. Any idea how I can fix this issue and proceed with the setup? Thank you for your time! (Attached is a picture of how far the verbose goes) Link to comment Share on other sites More sharing options...
SavageAUS Posted May 28, 2017 Share Posted May 28, 2017 Post clover folder as zip minus themes folder. Also pc specs. Sent from my SM-G930F using Tapatalk Link to comment Share on other sites More sharing options...
Foxic Posted May 28, 2017 Share Posted May 28, 2017 This is often due to bios settings, post a photo of each bios page. I had this problem with a few laptops and found excecute-disable bit capability needs to be available Link to comment Share on other sites More sharing options...
Recommended Posts