Jump to content

Unable to unmount volume for repair


RealVision
 Share

9 posts in this topic

Recommended Posts

I am trying to install macOS Sierra. It boots the installer and runs the first phase fine. However, in second phase when I select "Boot macOS install" it boots up, starts installing and gets an error "Unable to unmount volume for repair." Any ideas?

 

Hp Envy dv6
Intel Core i7 (Ivy Bridge)
8 GB RAM
Intel HD Graphics 4000
700 GB Hard Disk
 
previously I had el Capitan and worked perfectly, I used the same config.plist, kext from my el capitan but still no luck.
any help will be much appreciated.

post-1993409-0-13130900-1487819509_thumb.jpeg

  • Like 1
Link to comment
Share on other sites

  • 4 weeks later...

I solved here:

1. I installed MacOS first and left a space for install Windows 10 afterwards on HDD

2. Using a Linux distro I´ve used Gparted  and create a new NTFS partition on space I left for Windows

3. I´ve installed Windows without formatting the partition created by Gparted

Link to comment
Share on other sites

  • 3 months later...

I had the same problem, I fixed mine by creating the installation USB different way.
The problem I believe was due to the createinstallmedia tool. If the USB is in fact created with that tool, the installer divides the installation process into two. First, it copies the installation files to the HDD partition (that part creates problem), and then it reboots from that partition to install the files and eventually create the Recovery partition. The problem is that it for some reasons tries to unmount the partition it has booted from, which is obviously not possible; hence, it fails. The root problem probably has much to do with the partitions structure. In my case, I used MiniTools Partition Manager to migrate my Windows installation from my HDD to the new SSD drive. It could have been due to that, although MSR partition is also known to cause problems in some situations. The partition structure was as follow:

- ESP = EFI Partition

- MSR = Microsoft Reserved (culprit, too?)

- Win10 = Windows drive

- Sierra = New partition created for Sierra

- Macintosh HD = El Capitan drive (already installed and working)

- RecoveryHD = El Capitan recovery drive.

Solution: Use the "Restore BaseSystem.dmg" method. It's the vanilla way and it doesn't divide into two parts. Everything is done on the single step.

Link to comment
Share on other sites

  • 4 months later...
 Share

×
×
  • Create New...