Jump to content

Clover cant boot + wifi card not working


20 posts in this topic

Recommended Posts

Hello, i'm going through some stuff problems.

I could boot correctly the installer, the installation went ok but now. I did all the post installation steps.

  • Installed clover on my HDD
  • Copied my config.plist from the pen usb to my EFI partition
  • copied the required kexts
    • FakeSMC
    • RealtekRTL8100
    • VoodooPS2Controller

 

Ok, rebooted my pc to see if everything was ok, and than i encoutered a problem. The clover boot screen loads but when i select my HDD to boot, it tries to boot and than restarts.

I putted the -v flag to see what was going on, it showed the messages: "allocating memory.... ++++++++++" and reboot.

 

I fixed some problems with my config.plist and even with that i couldnt fix the problem.

 

My patched DSDT, SDST and config.plist are attached.

 

Other problem ive faced is my wifi card not working.

Ive patched the DSDT and installed AtherosWIFIinjector, IO80211 kext and even with that, nothing worked.

What can i do to fix all these problems.

 

Config:

Dell inspiron 14R 5347

GT 640M

atheros ar5b95

CLOVER.zip

Link to comment
Share on other sites

Why do you have VboxHfs and HFSplus? 

 

As far as I know, you can't use both at the same time. 

 

Regards,

 

Dwarfy 

 

He have VboxHfs in Pendrive, and in their HDD HFSPlus

 

The problem is in HDD + HFSPlus, that's right.

 

Correct if i'm wrong. It would make any effect on my HDD if they were inside of it, right? I can boot using usb without any problems...so they arent affecting anything. Right?

 

Doesn't make effect in your HDD.

 

Try boot your Hack using Pendrive, and in the HDD config.plist, mark the "Debug" option, reboot and try boot using HDD again.

 

Boot with Pendrive, and send us the boot.log inside "misc" folder.

  • Like 1
Link to comment
Share on other sites

He have VboxHfs in Pendrive, and in their HDD HFSPlus

 

The problem is in HDD + HFSPlus, that's right.

 

 

Doesn't make effect in your HDD.

 

Try boot your Hack using Pendrive, and in the HDD config.plist, mark the "Debug" option, reboot and try boot using HDD again.

 

Boot with Pendrive, and send us the boot.log inside "misc" folder.

First, should i remove the HFS from the hdd?

Second: even stopping on that screen ive showed, it should have created the boot.log? Because its not :(:wallbash: 

Link to comment
Share on other sites

First, should i remove the HFS from the hdd?

No.

 

Second: even stopping on that screen ive showed, it should have created the boot.log? Because its not :(:wallbash:

Setting up this option in config.plist of your HDD, doesn't make any effect? Strange...

Link to comment
Share on other sites

 Share

×
×
  • Create New...