Jump to content

Black Screen on Boot using Clover


leoporto
 Share

4 posts in this topic

Recommended Posts

Hello guys,

I was using chameleon to boot my yosemite and for obvious reasons I wanted to migrate to clover. On boot, I see clover, pick my osx disk, hit a black screen, nothing happens and it does not show any errors.

Selected configuration on Instalation (Clover EFI v2.3k r3577):
Install for UEFI booting only
Install Clover in the ESP
Drivers64UEFI/OsxAptioFix2Drv-64

config.plist major
boot args: -v kext-dev-mode=1 nv_disable=1
InjectKexts is set to Yes

Downloaded the most recent FakeSMC.kext and VoodooPS2Controller.kext and placed into kexts/Other/
Deleted numbered folders from kexts
Copied HFSPlus.efi to drivers64UEFI folder
Deleted VBoxHfs-64.efi from drivers64UEFI folder

After all that I keep running into a black screen on boot. Dont know what else to do. Would apreciate some help. THX

Link to comment
Share on other sites

Hi,

 

Try another memory related driver, EmuVariableUEFI64 for example. (If present, remove it.)

You can also try OsxAptioFixDrv-64.

 

Note, only 1 of these drivers should be installed.

 

Thx for the reply! Tried all items inside Drivers64UEFI, one by one and still getting black screen. Tried a few combinations of those drivers too. Still didnt work. I boot my yosemite using chameleon and chameleon doesnt use UEFI. Does that help in anything?

Link to comment
Share on other sites

 Share

×
×
  • Create New...