Jump to content

[SOLVED] Can't add/save (and therefore hide) Custom Entries in Clover


3 posts in this topic

Recommended Posts

Hi all-

 

I'm hopeful this is just a case of overlooking something obvious.

 

I'm trying to tidy up my Clover Boot Loader screen, I've started off by unchecking Legacy to get rid of the majority of unwanted partitions, so far so good.

 

Now I'm left with 4- an external USB drive that has a backup of OS X (which Clover is detecting), the OS X Recovery Partition, my El Capitan install, and Windows 10.

 

I'm trying to hide the USB drive, and the Recovery partition.

 

To start, I followed instructions, and added the Recovery partition as a Custom Entry under GUI- used the UUID as the Volume name, added a title, checked the box, set Hidden to Always- 

 

(I've also tried using the mBR record instead of UUID fyi), and using the Custom Legacy workflow).

 

The issue I'm having is that when I save the config, and exit Clover Configurator- then open it back up, the Custom Entry is gone!

 

Any other changes I make to the config save just fine (i.e when I unchecked Legacy, or if I change the resolution).

 

I've included a few screenshots- but ultimately the issue i'm having is my custom entries do not save.

 

Am I missing something obvious here?? 

 

For reference, the screenshot with NO custom entry was taken AFTER i had added the entry (and saved, close,d reopened clover configurator) you see in the other screenshot (and as you can see by the sequential timestamp in the screenshot file names)

 

Thanks!

post-8234-0-91675700-1462105857_thumb.png

post-8234-0-61345100-1462105865_thumb.png

Link to comment
Share on other sites

 Share

×
×
  • Create New...