sl1fka Posted April 30, 2016 Share Posted April 30, 2016 My usb was created with MacPwn (after several attempts at getting ##### to work failed...*sigh*)... Now when the USB is booted, Clover stays at "scan entries" and never gets off it. I've also tried vanilla installation guides that are here on this forum, and they get the same "scan entries" screen too. please help? Link to comment Share on other sites More sharing options...
luxinhaus Posted April 30, 2016 Share Posted April 30, 2016 what about introducing your HW to us Link to comment Share on other sites More sharing options...
sl1fka Posted April 30, 2016 Author Share Posted April 30, 2016 intel core i3-4160 3.6ghz amd radeon r9-270x 1tb hard drive 6gb of ddr3 ram gigabyte ga-z97-hd3 motherboard Link to comment Share on other sites More sharing options...
Needy Posted April 30, 2016 Share Posted April 30, 2016 Hello there, I'd recommend using the official way of creating installation media, which can be found if you follow the link below. https://support.apple.com/en-us/HT201372 After, you'll have to install clover on the same drive you used in the above guide. Attention, don't install clover on the EFI partition of that drive.In addition, you'll need a clean config.plist and configure it to match your needs. https://clover-wiki.zetam.org/Configuration#config-plist-structure If you succeed doing the above steps. Reply to this message and I'll guide on what to do next. Else Goto 1.Best regards. 1 Link to comment Share on other sites More sharing options...
sl1fka Posted May 1, 2016 Author Share Posted May 1, 2016 Thanks for the advice! I installed Clover to the ESP, so I'll try to install it without that option. Link to comment Share on other sites More sharing options...
Recommended Posts