speaker13 Posted April 11, 2016 Share Posted April 11, 2016 Hello all I am new here I would like to ask so some help. I have just bought a Surface pro 4. I have bought the i5 version. I have created a clover boot USB. This is not legacy boot. It boots fine in to El captain but I do not see my hard disk to install too. I have partitioned the drive as not formatted. I think the ssd in the drive is a Samsung nve. I found a kext for it but does not work. I looked in the install guide in the forums. Does not help with the ssd issue. Does anyone have any ideas thanks. Link to comment Share on other sites More sharing options...
JahStories Posted April 11, 2016 Share Posted April 11, 2016 Hi there! Take a look here! They managed to get it working using this driver. Good luck and have fun with your hack! Link to comment Share on other sites More sharing options...
blankmac Posted April 11, 2016 Share Posted April 11, 2016 Until someone develops an NVMe kext, the SP4 is essentially dead for anything other than an external install. If you have an install USB that is on 10.11.3 or less, it is possible to work around the issue by rolling back or eliminating the IntelLpssI2C and controller kexts and then adding the NVMe kext back in, but that's not going to cut it long term. Link to comment Share on other sites More sharing options...
JahStories Posted April 11, 2016 Share Posted April 11, 2016 Did you tried using the suggested driver? Link to comment Share on other sites More sharing options...
blankmac Posted April 11, 2016 Share Posted April 11, 2016 Yes, that works fine on 10.11.3 or less, but now kernel panics on 10.11.4. For whatever reason, rolling back or eliminating the i2c kexts will work, but that's not possible if you're working from a 10.11.4-based installer. 1 Link to comment Share on other sites More sharing options...
speaker13 Posted April 12, 2016 Author Share Posted April 12, 2016 Thanks and I thought I was doing something wrong. I downloaded the new version of el captain and did not see my hard drive. I guess we have to wait. Unless there is another idea. Thanks for the reply Link to comment Share on other sites More sharing options...
JahStories Posted April 13, 2016 Share Posted April 13, 2016 I would stay with 10.11.3 and that driver. Link to comment Share on other sites More sharing options...
speaker13 Posted April 13, 2016 Author Share Posted April 13, 2016 May I as how will I be able to remove i2c text? Thanks Link to comment Share on other sites More sharing options...
speaker13 Posted May 8, 2016 Author Share Posted May 8, 2016 Has any body found out how to get the Samsung driver seen in installing osx. Link to comment Share on other sites More sharing options...
Recommended Posts