Jump to content
17 posts in this topic

Recommended Posts

Hello, I loosed my all hope and came to write here again. I purchased a PC for using hackintosh.
 
I always have an unfortunate luck. I have purchased my custom build PC some days ago...I've asked for "Gigabyte GA-H97-D3H" Motherboard...But the seller given me "Gigabyte GA-H97-HD3" and I didn't notice that while I've purchased.
 
My Desktop PC Specs Are:
Processor: i5-4460
Graphics: Intel 4600
Ram: (8GB+4GB=12GB) DDR3
Mobo: Gigabyte GA-H97-HD3
HDD: Toshiba
PSU: Thermaltake 450w
 
 
Now the problem is: ------------------>
I can't install OSX Elcapitan 10.11 to my Desktop PC.
I'm showing the problem step by step:
 
I have clover installed USB-Bootable Pendrive. So entireing to my clover menu I add "-v" as boot args then "Boot OSX Base System"
Then some codes comes.....When the below image comes the monitor losts graphics and comes a blank black screen and after some some seconds monitor power goes off.
[ This happens so fast, So I captured this picture using camera shutter speed ]
c416786.jpg
 
 

Here is the example:

6a28163.jpg


Information About My Bios Setting:

 

Secure Boot: Disabled.

vt-d: Disabled.

SATA Mode: ACHI

Boot Device: Legacy Only
DMVT: 128MB [i can't make it less]
Intel Graphics: 64MB


Info about USB-Boot-Installer:

Usb: 2.0
8GB Size

OSX Version: 10.11



Now what can I do? Please help me....I'm waiting for your responses. [Note: I'm not much expert in this process]

 

This is my efi folder: https://drive.google.com/folderview?id=0B4u5uiV50s79NVEyS3lDNS0wVWM&usp=sharing

[ You can download it and check, if there's anything wrong, You can correct it and upload me back ]

Link to comment
Share on other sites

you dont need a fancy config during install.

extract and replace your config.plist with this

 

Hello, Thanks for your file. I have tried it and now its not going the graphics in that position,,,but now I am stuck in the picture below position...Please check..

c899c0e.jpg

Link to comment
Share on other sites

I'd suggest you to remake your USB. Follow this guide if you need to http://www.insanelymac.com/forum/topic/311440-el-capitan-installment-guide-by-a-noob-for-windows-users-without-mac/

 

Or this one if you got a Mac/Hackintosh. http://www.insanelymac.com/forum/topic/305255-making-a-10101011-usb-installer-w-clover-uefi-and-legacy-the-correct-way/?do=findComment&comment=2122209

 

This needs to be done the UEFI way. 

 

You need FakeSMC (from hwsensors.com, or you can use the FakeSMC from the EFI folder I gave you), OsxAptioFixDrv-64.efi and HFSPlus-64.efi (replace it with Vbox). 

 

I suggest you make your own USB, easier to "debug" your own problems in the future with it. Because the EFI you sent looked like if it was made for a laptop. 

 

Good luck. 

  • Like 1
Link to comment
Share on other sites

 Share

×
×
  • Create New...