Jump to content

Intel HD4600: impossible to boot to OSx


magneto5371
 Share

2 posts in this topic

Recommended Posts

Hello guys.

I am setting up my first Hackintosh. Here are the specs:

 

Mobo: Adlink M-342 with AMI Aptio 4 UEFI

Intel i3 2120 SandyBridge

4GB RAM

500 GB SeaGate HDD

 

So, here's the issue. The first part of the installation process works perfectly. At the end of the process, I am asked to perform a restart. I do that, it boots back to Clover. I select the HFS partition where I installed OSx, it loads for a while and then the screen goes blank.

The only way I found so far to be able to boot to OSx is to set a FakeID in Clover's Graphics Injection menu. The only FakeID that works is this one:

0x041680862

Which is not even a real FakeID. There is no other way, at the moment, to boot to OSx but this one, which is far from a perfect solution (the screen flickers every now and then and I cannot select resolutions different from 1024x768).

 

I really need help on this. HD4600 is known to be fully compatible with OSx, so nobody else has ever had this issue before (apparently).

Thanks for your help.

Link to comment
Share on other sites

Hello guys.

I am setting up my first Hackintosh. Here are the specs:

 

Mobo: Adlink M-342 with AMI Aptio 4 UEFI

Intel i3 2120 SandyBridge

4GB RAM

500 GB SeaGate HDD

 

So, here's the issue. The first part of the installation process works perfectly. At the end of the process, I am asked to perform a restart. I do that, it boots back to Clover. I select the HFS partition where I installed OSx, it loads for a while and then the screen goes blank.

The only way I found so far to be able to boot to OSx is to set a FakeID in Clover's Graphics Injection menu. The only FakeID that works is this one:

0x041680862
Which is not even a real FakeID. There is no other way, at the moment, to boot to OSx but this one, which is far from a perfect solution (the screen flickers every now and then and I cannot select resolutions different from 1024x768).

 

I really need help on this. HD4600 is known to be fully compatible with OSx, so nobody else has ever had this issue before (apparently).

Thanks for your help.

 

The i3-2120 is not HD4600. It is HD2000:

 

http://ark.intel.com/products/53426/Intel-Core-i3-2120-Processor-3M-Cache-3_30-GHz

 

HD2000 is not supported. You need a supported graphics card.

 

HD4600 comes with Haswell CPUs. Your CPU is Sandy Bridge (two generations behind Haswell).

 

Sandy... Ivy... Haswell.

  • Like 2
Link to comment
Share on other sites

 Share

×
×
  • Create New...