hamzaniko Posted December 31, 2015 Share Posted December 31, 2015 (edited) Is there a solution to gtx 970 to make it work with nvidia web driver ? Still cant boot without nv_disable=1 when i instal the web driver i replace it the nvda_drv=1 so after clover bootloader i get black screen and display goes save mode my reg is asus maximus viii hero + i5-6600k and gigabyte gtx 970 4gb g1 i already tried change smbios to 14.2 and 15. and apply this fix in this thread xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx but i get no luck still the same thing Edited December 31, 2015 by fantomas1 tonymac link removed! Link to comment Share on other sites More sharing options...
rlf Posted January 1, 2016 Share Posted January 1, 2016 Read this thread: http://www.insanelymac.com/forum/topic/308790-applegraphicsdevicepolicy-on-the-fly-patching-impossible-alternate-idea-but-still-does-not-seem-to-work/ Either use the posted patch for Clover or go to the following file and find the Mac identifier for your board under ConfigMap and change the parameter from "Config1" to "none": /System/Library/Extensions/AppleGraphicsControl.kext/Contents/PlugIns/AppleGraphicsDevicePolicy.kext/Contents/Info.plist Link to comment Share on other sites More sharing options...
hamzaniko Posted January 1, 2016 Author Share Posted January 1, 2016 i tried it still black screen and display save mode !:/ Link to comment Share on other sites More sharing options...
hamzaniko Posted January 1, 2016 Author Share Posted January 1, 2016 i set every boot flag and used the patched kext and tried it ! still the only way i can boot is with nv_disable=1 ! i also tried smbios 15.1 and 14.2 and 3.1 with patched kexts and 6.1 with editing the config and with patched one ! stil the same ! :/ this is my clover file the one that i instaled the system with befor i begin try any solution see if there any problem in it that probebly cause this http://uptobox.com/4x95cam289sa Link to comment Share on other sites More sharing options...
hamzaniko Posted January 2, 2016 Author Share Posted January 2, 2016 Thank you for the reply first answer is yes i usr hdmi cable and trying to boot el capitan 10.11.1 and clover is indtaled on the hard drive so ! Can you direct me to a thread guid to make bootable usb with enoch if is there a way i can do a fresh instal to see if it works and again thank you for your time Link to comment Share on other sites More sharing options...
Recommended Posts