YanekR Posted October 5, 2015 Share Posted October 5, 2015 Hi Guys, I have big problem with configuring my bootable usb with clover. I do not know where is a problem but installation on my PC could not start up, still getting error sign. Would be able to help me with configuring my bootable pen? My specification: MoBo: Asus P8Z77V-LX2 Graph: Gigabyte Radeon R9 280X RAM: 32 GB 1866MHz Proc: Core i7 3770k I have tried to setup Bios accordingly to tutorials ( AHCI, Other OS, CSM disable (tried also with enable) I would appreciate for any help from your side!\ Thanks, Yanek_R Link to comment Share on other sites More sharing options...
rlf Posted October 5, 2015 Share Posted October 5, 2015 On Yosemite or earlier: Insert the USB drive. Open Disk Utility. On the left pane, select the USB drive. Click on the drive, not any partitions that might be on it. On the right side, click on Partition. In the pop-up menu, select 1 partition. Set it to Mac OS Extended Journaled Click the Options button and select GUID Click on the Apply button. Run the Clover installer. Select the USB drive, click Continue Click on the Customize button Select Bootloader -> Install boot0af in MBR Select Themes -> (whatever you like) Click the Install button Reboot the computer Use the UEFI/Bios selector to select the USB drive to boot (F11, F12, F8, whatever it is on your computer) Boot the USB drive 1 Link to comment Share on other sites More sharing options...
YanekR Posted October 5, 2015 Author Share Posted October 5, 2015 On Yosemite or earlier: Insert the USB drive. Open Disk Utility. On the left pane, select the USB drive. Click on the drive, not any partitions that might be on it. On the right side, click on Partition. In the pop-up menu, select 1 partition. Set it to Mac OS Extended Journaled Click the Options button and select GUID Click on the Apply button. Run the Clover installer. Select the USB drive, click Continue Click on the Customize button Select Bootloader -> Install boot0af in MBR Select Themes -> (whatever you like) Click the Install button Reboot the computer Use the UEFI/Bios selector to select the USB drive to boot (F11, F12, F8, whatever it is on your computer) Boot the USB drive Did it already but no luck :/ Now I try from other USB port, but again stacked :/ I will try to do a clean install again. by Run the Clover installer. you mean what I can find i this this topic? Thanks, for your help Link to comment Share on other sites More sharing options...
YanekR Posted October 5, 2015 Author Share Posted October 5, 2015 Yep, Was enough to read more posts on this amazing forum. It occurs that the issue was with USB ports. All installed - now post installation Thanks Guys! Link to comment Share on other sites More sharing options...
Recommended Posts