zastin17 Posted July 12, 2015 Share Posted July 12, 2015 (edited) So I have installed mac OS X with clover and I have noticed when booting into mac OS X the boot process bar reaches around 1/4 of the way then the monitor flashes on and off a few times and then I'm at the desktop. No full boot and no pretty transition to desktop. I'm guessing this happens because when OS X reaches the 2nd boot stage. The graphics card gets enabled fully. Is there a way to fix this? is there a way to enable the graphics card before booting into OS X? I found this post here but I'm not sure how to install this fix let alone if it will work. Edited July 12, 2015 by Micky1979 link to tonymac removed Link to comment Share on other sites More sharing options...
Micky1979 Posted July 12, 2015 Share Posted July 12, 2015 we don't support tonymac, re-read the rules. Link to comment Share on other sites More sharing options...
zastin17 Posted July 12, 2015 Author Share Posted July 12, 2015 we don't support tonymac, re-read the rules. OK fine. No tony mac. The code is: but I don't know how to install it or where to install it. <key>KextsToPatch</key> <array> <dict> <key>Comment</key> <string>Second Stage Patch 1</string> <key>Find</key> <data>hcB0XUg=</data> <key>Name</key> <string>IOGraphicsFamily</string> <key>Replace</key> <data>McB0W0g=</data> </dict> <dict> <key>Comment</key> <string>Second Stage Patch 2</string> <key>Find</key> <data>QYjE6wM=</data> <key>Name</key> <string>IOGraphicsFamily</string> <key>Replace</key> <data>QYjE6yM=</data> </dict> </array> Link to comment Share on other sites More sharing options...
Recommended Posts