Jump to content

Nvidia 9300GE osx 10.8


dude998866
 Share

4 posts in this topic

Recommended Posts

Ok, so I'm not new to hackintoshing, I've built 4 or 5, but this one has got me a little stumped. I've installed 10.8, and everything works except for the graphics. After booting I get the "no signal" message on my monitor. I've had this before with other cards, those were solved with an EFI string in the boot.plist. Not so with this one.

 

It will boot however if I use the flag nv_disable=1 Then its fine, minus acceleration. I've done much seaching, and after finding this thread, think I'm getting close

http://www.insanelymac.com/forum/topic/289000-nvidia-geforce-9300ge-solved/

 

However the modified kext file he linked to is gone :(

 

 

So, does anyone know how he might have modified the NVN50Hal.kext? I assume he probably put in a device ID somwhere, but this is where my knowledge fails me as I've not had to do that before.....

 

 

So, any ideas\help woyuld be greatly appreciated.

Link to comment
Share on other sites

Hello, gigabyte board right?. GA73PVM-S2H here. had same problem on 9800GT, PCIRoot=1 or PCIRootUID=1 (use both) fixed problem for me! :) + GraphicsEnabler=Yes. on 10.9 :)

Used niresh distro mavericks, and there choosed boot flag with that pcirootuid/pciroot, and graphicsenabler=yes.

Link to comment
Share on other sites

Well I'll be damned. The combination of PCIRootUID=1 and PCIRoot=1 did it. Graphics work perfectly. I tried with each one individually and it did't work. Tried them together and off it went.

 

Thanks!

Link to comment
Share on other sites

 Share

×
×
  • Create New...