yossarian22 Posted April 6, 2015 Share Posted April 6, 2015 I have the Yosemite installer on my USB stick and I get Clover to boot fine, but when it tries to launch the installer it does this: Any idea what's causing that? Link to comment Share on other sites More sharing options...
crusher Posted April 6, 2015 Share Posted April 6, 2015 Look bro I have a same mobo. Today I sent you config for mobo. Link to comment Share on other sites More sharing options...
yossarian22 Posted April 7, 2015 Author Share Posted April 7, 2015 Look bro I have a same mobo. Today I sent you config for mobo. Thanks, but I didn't get it in PMs or email, please send again, or post up somewhere ty Link to comment Share on other sites More sharing options...
crusher Posted April 13, 2015 Share Posted April 13, 2015 I am sorry I am now on vacation!!!!! Link to comment Share on other sites More sharing options...
blankmac Posted April 13, 2015 Share Posted April 13, 2015 Try adding npci=0x2000 to your boot flags. You should be able to remove it after it's installed. Link to comment Share on other sites More sharing options...
shrieken213 Posted April 20, 2015 Share Posted April 20, 2015 I'm using Clover, 4790K and GTX 770 on that exact board fine. It's getting here in a week or so from transit. It's probably a BIOS setting or bootloader config fault. I'll send both configs plus my DSDT to ya. Link to comment Share on other sites More sharing options...
crusher Posted April 21, 2015 Share Posted April 21, 2015 Ok I attach config.plist for your USB and post installation method . Yes and RehabMan FakeSMC.kext. Yes post full configuration of your PC Link to comment Share on other sites More sharing options...
Recommended Posts