Vendetta V Posted March 10, 2015 Share Posted March 10, 2015 Hey everyone, I've been really frustrated for over a year now trying to use clover as opposed to Chameleon. With a recent unintended update on mavericks it kind of yield into kernel panics so I really started wanting Clover and Yosemite. So far, I got the mavericks install working ok, but I'd really wanna update to yosemite and use clover with it. Clover on the other hand doesn't wanna bulge, with all the settings i've tried back in the days it would yield a boot0: error. I never went past that and never actually had a clover boot on my computer. The config is pretty simple: i5 and HD3000, everything works consistently with Chameleon, except sleep. Everything else is completely fine as I said. Bios is patched. Cheers, appreciate your input. Link to comment Share on other sites More sharing options...
Allan Posted March 10, 2015 Share Posted March 10, 2015 Hi and Welcome to InsanelyMac forum! About Sleep read here: Sleep, Hibernation - How it Works? and How to use? Link to comment Share on other sites More sharing options...
artur_pt Posted March 10, 2015 Share Posted March 10, 2015 hello if u have boot0 error u are trying to use clover in legacy boot not uefi if is the case the procedure is like this boot0:error easiest way to fix it and must read about clover boot loader .. is bible.. and is nice u explain in detail what u try to do.. http://clover-wiki.zetam.org/Contents good hack Link to comment Share on other sites More sharing options...
Codinger Posted March 10, 2015 Share Posted March 10, 2015 Whats your PC Model? Link to comment Share on other sites More sharing options...
Vendetta V Posted March 10, 2015 Author Share Posted March 10, 2015 Hey guys thanks for the responses so far. my PC model is Dell inspiron 17r (n7110) I've heard the inspiron 15r and 17r do have the sleep mode working on clover but Chameleon can't do it. I'm currently using a Chameleon bootloader. I'm wanting to give a try to clover again with the 4drive fix suggested above. How should I go about this? I already have a working OSX with the chameleon bootloader so should I just go to disk utility and then do the terminal command thru the actual working OSX? If clover still doesn't work, can this make the computer not run from Chameleon either? Or is there no risk, the worst that could happen is clover won't work and I'll still be using a Chameleon booloader? (I'm booting from a flash by the way) Link to comment Share on other sites More sharing options...
Recommended Posts