rev4turbomonster Posted January 31, 2015 Share Posted January 31, 2015 Guys can you help please I can't get into the installer have used the install creater from terminal and clover r3147 I think. What am I doing wrong here is a screen shot please help if you can Regards Matt Link to comment Share on other sites More sharing options...
martin_weiss Posted February 4, 2015 Share Posted February 4, 2015 What does your config.plist look like? I had the same problem using Clover the first time and it was because I had ticked off some options in the Acpi section (which shouldn't be ticked off). Link to comment Share on other sites More sharing options...
rev4turbomonster Posted February 4, 2015 Author Share Posted February 4, 2015 I have managed to get it to boot to the installer and installed yosemite. I have not yet set up clover because I have no idea what options to install it with. Any chance you could help me with that please Link to comment Share on other sites More sharing options...
Rampage Dev Posted February 4, 2015 Share Posted February 4, 2015 To start make sure you are on the latest BIOS version. Use my install guide here: http://www.rampagedev.com/?page_id=144 Use the Clover config and the kexts on the Haswell DMG for the installer: http://www.rampagedev.com/?page_id=50 This should allow you to boot into the install with full onboard graphics. Might have to play around with the Memory setting in the BIOS. 1 Link to comment Share on other sites More sharing options...
rev4turbomonster Posted February 4, 2015 Author Share Posted February 4, 2015 Hi thanks for your help I feel I have progressed in the sense that I have at least got clover on the drive and it loads to that point giving me the options to boot however when I try to boot I get to this and it hangs any ideas please. Once again thanks for your help Link to comment Share on other sites More sharing options...
rev4turbomonster Posted February 9, 2015 Author Share Posted February 9, 2015 Hi guys, I now have this machine up and running and it is running well. Only thing I can't get to work is continuity. I thought it would work with the chipset of the on board bluetooth but it isn't having it. Anyone know how to get it working. Thanks Matt Link to comment Share on other sites More sharing options...
gengik84 Posted March 27, 2015 Share Posted March 27, 2015 hi, I followed the guide. The installation starts and then stops. Launched in verbose ... remains stationary on Dsmos has arrived. I kindly ask you to help me. Sorry for my English. Link to comment Share on other sites More sharing options...
Recommended Posts