Jump to content

Rebooting right after "PCI Configuration Begin"


garry__
 Share

1 post in this topic

Recommended Posts

My system was running fine until I updated the audio kext:

 

post-420742-0-60358500-1420543826_thumb.jpg

 

I installed the audio kext [link] that RampageDev shared in these forums using Kext Wizard, after which I repaired system permissions + updated caches. I then reboot my system and since then haven't been able to get past here. After the "PCI Configuration Begin" part, the system loads a black screen from which it almost instantly reboots the entire system.

 

Anyone have any suggestions?

 

EDIT: I just did a fresh installation and everything is working smoothly for now..

Link to comment
Share on other sites

 Share

×
×
  • Create New...