Dhanuka8000 Posted December 21, 2014 Share Posted December 21, 2014 Hi, I've recently updated my OS X Snow Leopard using a combo update from 10.6.3 to 10.6.8. After this process it required a reboot and I followed it's request and now when I try to boot into OS X it just gets stuck at the spinning wheel. I've tried the following commands but none have worked: -s -f -v GraphicsEnabler=No npci=0x2000 Here's what I get when I put in verbose mode: Link to comment Share on other sites More sharing options...
mendietinha Posted December 21, 2014 Share Posted December 21, 2014 welcome to insanelymac! please post a pic without the -s flag. use only the -v flag. and post your specs please. Link to comment Share on other sites More sharing options...
Dhanuka8000 Posted December 21, 2014 Author Share Posted December 21, 2014 Specs: Acer Aspire 5733 Intel Core i3-370m Intel HD Graphics 512MB GDDR3 1st gen 4GB DDR3 RAM 500GB HDD After only using the '-v' flag: Also thanks for the warm welcome Link to comment Share on other sites More sharing options...
mendietinha Posted December 21, 2014 Share Posted December 21, 2014 no problem. well you wont get graphic support unless you go to mavericks or yosemite. they have a topic in the graphics sub-forum showing how to enable full acceleration. give it a read and go for mavericks or yosemite. no reason to use an old and unsupported os x. Link to comment Share on other sites More sharing options...
Dhanuka8000 Posted December 21, 2014 Author Share Posted December 21, 2014 Right but how do I get a hold of a working/bootable yosemite or mavericks copy because I've got a copy of yosemite on my usb stick but I keep getting the following kernel panic when I go to boot the installation: Link to comment Share on other sites More sharing options...
mendietinha Posted December 21, 2014 Share Posted December 21, 2014 the aio for hackintosh under the genius bar sub forum has all you need. take a good read. 1 Link to comment Share on other sites More sharing options...
Dhanuka8000 Posted December 21, 2014 Author Share Posted December 21, 2014 Okay thank you very much, I found what I needed! Thank you for your time and have a good day 1 Link to comment Share on other sites More sharing options...
mendietinha Posted December 21, 2014 Share Posted December 21, 2014 no problemo. you too! Link to comment Share on other sites More sharing options...
Recommended Posts