[HELP] Cannot get full resolution on Clover boot GUI

[thy1225]

Here's my setup, 

 

I can't get the clover boot GUI full resolution (1920x1080)

 

Here's what I tried so far:

 

     - no custom EDID, No Patch VBios, No PatchVBiosBtyes  -->   GUI shows like squashed 1920x1440

 

     - with or without custom EDID, Patch VBios Enable, no PatchVBiosBytes  -->  GUI shows like stretched 800x600

 

     - with or without custom EDID, NO Patch VBios Enable,  with PatchVBiosBytes  -->  GUI still shows like stretched 800x600

       (with PatchVBiosBytes:  find "gAeoAqAF"  replace "gAeoAjgE" )

       I attached the boot log of this test.

 

what else I missed ? 

attached the clover config.plist

 

 

my setup:

Clover v2k r2999

Yosemite 10.10.1

CPU Sandy i7

Gigabyte P67A-UD3R-B3   -->  Non UEFI

Intel 120G SSD

DDR3 8G Memory

 

 

config.plist.zip

bootlog.log.txt.zip

[X-TRiAL]

What drivers are you using? 

For full res you should use CsmVideoDxe-64.efi, it works fine for me and I do not need to change any values in my config.plist. 

[thy1225]

What drivers are you using? 

For full res you should use CsmVideoDxe-64.efi, it works fine for me and I do not need to change any values in my config.plist.

 

No, I didn't use CsmVideoDxe-64.efi, I thought my motherboard doesn't support EFI, it's a Gigabyte P67A-UD3R-B3

Can I use that driver ?

Please Help me on this    thanks~

 

here's all the driver I installed so far: