Jump to content

OPEMU: ud2 - Vanilla 10.9.1


Kyle F.
 Share

1 post in this topic

Recommended Posts

Hey guys...

 

I'm trying to make a full vanilla Mavericks 10.9.1 installation so I can use that instead of Niresh because, well...Niresh' distro doesn't have Ethernet drivers/support OOTB...yet I've seen a lot of AMD users install a vanilla Mavericks and right after the initial post-setup (creating the account etc) their Ethernet works instantly! So I'm going to try. And if it works, all being well...I'm going to do a Time Machine restore for my applications and files etc to the new vanilla installation. The only issue I'm having is getting into the installer itself. When it tries to boot from my USB stick, it boots, the verbose mode comes up and loads everything it needs to start booting into the installer but then it spams "OPEMU: ud2" down my screen and does not proceed at all.

 

Could anyone help shed some light to this annoyance?

 

Thank you.

Link to comment
Share on other sites

 Share

×
×
  • Create New...