Jump to content

Clover won't boot Yosemite


Rubenca
 Share

7 posts in this topic

Recommended Posts

Hi,

 

I installed Yosemite successfully with using clover, adding FakeSMC.kext to the 10.10 kext folder and I was good to go (I'm using clover in UEFI mode only).

 

Now post installation I'm trying to get clover working in my EFI partition (the same way as I did before for Mavericks), but when I try to boot my installed Yosemite with injected kexts, nothing happens.

 

The only kext I need is FakeSMC, otherwise my motherboard is fully compatible.

 

This is a clean install (no dual boot nonsense)

 

Attached is my clover config, anyone have an idea what I'm doing wrong this time?

 

Specs:

16 GB Corsair Dominator Ram 1600 Mhz

Core i5-4690K CPU

Maximus Gene VI Motherboard (ASUS)

GTX 780 EVGA

Clover v2k r2774

config.plist.zip

Link to comment
Share on other sites

Do you mean those separate kexts included with hwsensor? I do have those added to the 10.10 kext folder indeed.

I'll try and remove them. By the way I can boot fine with my USB stick to my Yosemite install with those kexts included...


Edit: Just tried removing those kexts (ACPISensors, CPUSensors, ...) Didn't help. Unless you meant something else wit those FakeSMC plugins?

Link to comment
Share on other sites

yeah removed that one as well, like I said my kexts that I load and config are the same as what I have on my USB Stick.

 

However my clover install in the UEFI partition, will not boot 10.10. As soon as I choose boot with injected kexts, it immediately freezes on this step:

 

root device uuid is...

 

Edit: Moving the kexts to the "Other" folder also didn't help

 

Are there specific UEFI Clover drivers that I absolutely need?

Link to comment
Share on other sites

 Share

×
×
  • Create New...