Kikill3r Posted May 26, 2014 Share Posted May 26, 2014 Hello community, I finally managed to install Clover without those nasty boot0 and boot1 errors. But when I now boot my computer, after the POST there is just that blinking "_" for 4-5 seconds. Then a "7" appears on the screen for 3 seconds. After that, the computer just restarts. I searched for a solution for hours but didn't find anything. Please help me! System specs: Fujitsu T8100 Core 2 Duo T8100 GMA 965 graphics chipset (X3100 core) which is not supported of course, so I work with VESA 3.0 Graphics 1024x768 internal display Link to comment Share on other sites More sharing options...
Gringo Vermelho Posted May 26, 2014 Share Posted May 26, 2014 You need to install/configure Clover so that it boots in Legacy mode. Clover boots in UEFI mode by default, which will not work on your laptop. Don't ask me how, I use Chameleon. X3100 graphics are fully supported in Lion, but the drivers are 32-bit only. Lion is the last OS you can run with full support because it is the last version of OS X that can run in 32-bit kernel and drivers mode. Link to comment Share on other sites More sharing options...
Kikill3r Posted May 27, 2014 Author Share Posted May 27, 2014 Thanks for your quick reply!I surely installed it in Legacy Mode.I opened another thread on my Lion graphics problems... It may be something with the framebuffer...Here is the thread: http://www.insanelymac.com/forum/topic/296078-intel-gma965x3100-problem-in-32-bit-mode/I have currently installed Niresh's Mavericks. Link to comment Share on other sites More sharing options...
Recommended Posts