jaakoe Posted May 12, 2014 Share Posted May 12, 2014 Hey guys, I've just installed snow leopard using nawcom's ModCD, at the installation i took Legacy, AppleATIATA, VoodooHDA and PS / 2 Support. So i wanted to boot it with the ModCD after the installation but it doesnt continue at the text since 20 minutes now. A picture of the screen is attached. I got an AMD Phenom II X4 and a asus m4a77t/usb3. I've already installed os x yesterday and i was able to but with the ModCD and installed chameleon but when i booted from my hdd i got a kernel panic so i wanted to install it again and now i got this problem. Hope you can help me. Edit: Well, I've just rebotted 2 times and its working now close please Link to comment Share on other sites More sharing options...
rsmith2904 Posted February 20, 2015 Share Posted February 20, 2015 I'm having a similar problem. I copied and printed the instructions that were on Hackintosh.com which said to run the mod-cd and when it loaded, to remove it and put the Snow Leopard cd in and press f5. when it finished loading the black & white screen and said press any key to continue, and then swap the OS X disk back to the mod-cd disk, which I did, and it put me into a "Zero Happening situation". It was supposed to be loading the files to the hard drive to allow it to boot on it's own, but nothing happens. It sits there in a dos screen with a statement that says "Verifying dmi pool data. And there's where it stays for hours. I have had the screen that you're showing, but figured out why I got it, but I just don't have an answer for what I'm currently going through. Link to comment Share on other sites More sharing options...
Recommended Posts