brianmoyano Posted April 15, 2014 Share Posted April 15, 2014 Hi, about 3 months ago i finally made i very successfull installation, the hardware was: Intel® Core™ i5-3570k @ 3.8Ghz Gigabyte GA Z77M-D3H Kingston HyperX 4GB DDR3 @ 1666Mhz Intel HD4000 @ 64MB [VGA] Seagate Barracuda 1TB 7200rpm Samsung SyncMaster P2350 23" VGA CoolerMaster Extreme Series 500W And now, the other i bought a brand new GTX 760. So i installed it and run osx. I didn't have to do anything, working out of the box. But today my hdd broke and i have to make a new installation in a new one, so i made a booteable usb with transmac, but when i boot i get the following kp: So, i unplugged the gtx 760 and tried again with the onboard hd4000, and then the same message. Also, set my bios settigns to default. I don't know what is causing it. Link to comment Share on other sites More sharing options...
iFIRE Posted April 15, 2014 Share Posted April 15, 2014 seems that FakeSMC.kext not present or not read Link to comment Share on other sites More sharing options...
brianmoyano Posted April 15, 2014 Author Share Posted April 15, 2014 seems that FakeSMC.kext not present or not read I'm going to download it again, it may help? Or what can i do? Link to comment Share on other sites More sharing options...
iFIRE Posted April 15, 2014 Share Posted April 15, 2014 of course, if this kext not present or not read, you can't install the system, I never make a USB with transmac, but in the photo I see dmg=file///BaseSystem.dmg I think that is wrong, check if you make this correct here a bit of info https://www.dropbox.... OS Windows.zip VMWare desde windows: [ NooBs Guide ] How to install OS X Mavericks from scratch in progress - Tutorials (The Genius Bar) - InsanelyMac Forum [Guide] Creating OS X USB installer using a Windows PC only - Tutorials (The Genius Bar) - InsanelyMac Forum #18 [Guide] Creating Mavericks USB Installer using Windows+Hirens - pdf - Tutorials (The Genius Bar) - InsanelyMac Forum [Guide] How to make a bootable OS X 10.9 Mavericks USB install drive on LINUX - OSx86 10.9 (Mavericks) - InsanelyMac Forum 1 Link to comment Share on other sites More sharing options...
Gringo Vermelho Posted April 15, 2014 Share Posted April 15, 2014 What bootloader did you use? Try adding UseKernelCache=n to your bootflags But yeah BaseSystem.dmg...that's not right I think.. Link to comment Share on other sites More sharing options...
fusion71au Posted April 17, 2014 Share Posted April 17, 2014 How exactly did you make your USB installer ie what was the procedure followed? I assume you are using Clover as you mentioned in this thread and the same config.plist? Make sure you have FakeSMC.kext in EFI/CLOVER/kexts/<osx version> and when booting the USB installer, Select "Boot Mac OS X without caches and with injected kexts" and press <spacebar> as shown below... Link to comment Share on other sites More sharing options...
Recommended Posts