Medice Posted February 9, 2014 Share Posted February 9, 2014 Hello, Guys, i have some trouble with my ASUS P5G41T-M LX, i put in the Nawcom-BootCD and boot from it, after that i choose my internal Partition wich hold the Retail-DVD installation-files and press enter... Many hundred kexts will be loaded... from hd(0,2)/System/libary/extensions... it goes after three screens to a point where i can see my CPU and RAM and have to "press a key to continue"... after that the USB-Ports will be loaded and for a short moment there is a line that begins with "System...." and a KP apears... "cant find Driver for this Plaform "ACPI"..." it is the same KP Screen what is shown here: http://www.insanelymac.com/forum/topic/269841-install-snow-leopard-on-any-pc-for-anybody-includes-windows-dual-boot/?p=1757743 =( but i dont know what to do?! =( Link to comment Share on other sites More sharing options...
HiPhiOSx86 Posted February 15, 2014 Share Posted February 15, 2014 I'm a newbie here, but I have just used the nawcom isntaller on a very old Pentium 4 HT 3.4 GHz 32 bit machine. I burnt the Nawcom to CD (*as a MASTER Bootable) - restarted the PC - F2 to BIOS - default settings - reboot to F2 - enabled (in my case) the 32 bit address & boot sequence to DVD/CD, saved and rebooted - F12 to select DVD/CD again (just to be certain) as boot - nawcom opened & I got an icon - eject nawcom from dvd/cd drive - replaced with OS X 10.6.3 install dvd & closed tray - pressed F5 to rescan buses and see installer - off it went. When it finished, I selected installed HD in the restart utility - boot back to nawcom only now you see two icons, nawcom cd & HD with install on it - select installed HD & enter - boot into osx86 Once I'd done it once, I did it a few times experimenting with settings, but seems to be ok now, after fixed the sleep issue. No wifi, but the netgear usb dongle I tried is unsupported as far as I can see. I'll have to go and get a pci realtek chipset card. Link to comment Share on other sites More sharing options...
Slice Posted March 4, 2014 Share Posted March 4, 2014 Hello, Guys, i have some trouble with my ASUS P5G41T-M LX, i put in the Nawcom-BootCD and boot from it, after that i choose my internal Partition wich hold the Retail-DVD installation-files and press enter... Many hundred kexts will be loaded... from hd(0,2)/System/libary/extensions... it goes after three screens to a point where i can see my CPU and RAM and have to "press a key to continue"... after that the USB-Ports will be loaded and for a short moment there is a line that begins with "System...." and a KP apears... "cant find Driver for this Plaform "ACPI"..." it is the same KP Screen what is shown here: http://www.insanelymac.com/forum/topic/269841-install-snow-leopard-on-any-pc-for-anybody-includes-windows-dual-boot/?p=1757743 =( but i dont know what to do?! =( This message corresponds to bad DSDT. You have to prepare your best DSDT or use Clover that propose you automatic patching. Link to comment Share on other sites More sharing options...
Recommended Posts