Jump to content

10.8.2 working on Dell - how do I transfer ability to see hard disk to new USB myHack


GoGas
 Share

3 posts in this topic

Recommended Posts

Dell Inspiron 530 is working with 10.8.2. This was built about 1 year ago and at time had lots of issues in getting the myHack install to see the hard disk (frequent reported issue with Dells). Tried so many aspects but eventually got it working with extra kexts in E/E (can't remember if I also replaced some in S/L/E ??). I have created a myHack 10.9 but cannot see the internal hard disks on boot. From notes at time I have copied the E/E of working 10.8.2 internal hard disk to myHack USB but it still cannot see internal hard disks. 

 

Any suggestions as to what I can do to / copy replace from the working 10.8.2 to myHack USB to get it to see disks? It seems something to do with the AHCI, IOATA, IOAHCI and have tried an extended AHCI Injector but not sure what I should be adding and would I should be removing. Frustrating as working on 10.8.2

 

Any suggestions?

 

Thanks

Link to comment
Share on other sites

Thanks . I had seen that thread and tried it , although with the 10.8.2 kexts as no access to 10.8.4. I will make new MyHack and (1) change the kexts as suggested and if that does not work (2) replace the E/E in its entirety from working 10.8.2 but not sure 10.9 will like that.

Link to comment
Share on other sites

 Share

×
×
  • Create New...