I tried to install 10.6 retail on my PC. My PC got the following hardware:
Intel Core2Duo E8400
ASUS P5Q motherboard
4GB DDR2 @ 1066 MHz
Club 3D ATi HD4870 / 512 MB
PLEXTOR 64 GB SSD
1,5 TB WesternDigital HDD
Realtek 1839 familiy PCI-E ethernet-card
LG BluRay drive
I use the latest ##### version to boot up the 10.6 MacOS retail disk (I just noticed that software from tonysmac isn't supported here, so I'm not sure if I can get help here anyway? ). I start the installtion with the following commands "-v -graphicsenabler=no -pcirootuid=0". When the installation starts I can see all the nice stuff is going on. It takes a while and I can see that the setup loads my hardware, finds all my HDD-drives, etc... At some point the installation-log scrolls super-fast and I can't really see whats going on there. I think the last message it shows is something with NTSF, but I'm really not sure, as it vanish very fast. And then the installation suddenly stops with some artifacts as you can see on my screenshot.
Do you guys know what can cause this issue? Or do you need more informations? If so, is it possible to get a log-file with the error-messages somewhere or is it deleted once I reset my PC? I can remember, that I got 10.6 SL running on the same PC a while ago. So I'm pretty sure it will work, but I just can't recall how I did it .
Thank you for your time .