rajkosto Posted August 3, 2013 Share Posted August 3, 2013 Acer Aspire 5742G laptop i5 nehalem (laptop produced oct 2009) ddr3 1066MHz 4GB (2x2GB) arrandale MCH geforce 420m with 1024MB vram (discrete graphics only, intel graphics on cpu disabled by mobo) using clover r1942 http://files.rajko.info/config.plist clover config http://files.rajko.info/original_dsdt.zip original dsdt UEFI version clover is booted on: 2.00 InsydeH2O so im using OsxLowMemFixDrv, not AptioFix Slight graphical corruption on the bottom 5 lines, and on a rectangle bottom right (permuted boxes getting blit?) nspci=0x3000 doesnt seem to do anything if it's even enabled I have BusSpeed set to 133000 in config.plist of clover because that's the value both CloverEFI and UEFI-run clover detect (should it be 133333 ?) Used injected kexts: FakeSMC.kext (from HWSensors_rev720_Release_10.6.tar.lzma), NullCPUPowerManagement.kext, VoodooPS2Controller.kext (without which i have no kb/mouse support on laptop) Problem: http://i.imgur.com/iwqyqWs.jpg bless shouldn't really do anything, should it ? Maybe suggest me some DSDT fix bits to set ? I could have them as 0, or just HPET, but enabling Warning fix makes it fail on initial darwin boot with : 'unable to find driver for this platform ACPI'. Also, even though clover wiki says it's harmless if enabled, PatchAPIC set to true makes it hang after AppleAPIC... CPU listing thing Link to comment Share on other sites More sharing options...
xpamamadeus Posted August 3, 2013 Share Posted August 3, 2013 Try adding EmuVariableUefi-64.efi driver. Link to comment Share on other sites More sharing options...
rajkosto Posted August 3, 2013 Author Share Posted August 3, 2013 Thanks, that made it reboot instead of panic there, and i got the boot entry to resume installation now (it panics immediately after, but i can try fixing that tomorrow) The reason i thought i didn't need EmuVariable driver is because my firmware already has that DXE module, should i try and replace it in my firmware so that i don't need the driver in clover ? Here's the version i got in my firmware: http://files.rajko.info/CBD2E4D5-7068-4FF5-B866-9822B4AD8D60.efi Link to comment Share on other sites More sharing options...
xpamamadeus Posted August 3, 2013 Share Posted August 3, 2013 now try without cpu section in config.plist and without dsdt fix Link to comment Share on other sites More sharing options...
rajkosto Posted August 3, 2013 Author Share Posted August 3, 2013 I had to copy kexts to inject to 'Other' folder, not just 10.8 I guess 1st stage installer (from the dmg file) is considered 10.8, but 2nd stage is Other (didnt really find info about that) Now installation is proceeding, will see what happens next Link to comment Share on other sites More sharing options...
Recommended Posts