Jump to content

Dsdt for Tohiba r705


real_didi
 Share

11 posts in this topic

Recommended Posts

Thank you very much for your time iFIRE.

 

I've dropped that file to /Extra and got kernel panic.

 

First at chameleon starts i got this:

(Header size 200 and Incorrect image signature)

post-887143-0-31066300-1368987480_thumb.jpg

 

Boot ends at this:

post-887143-0-40252500-1368987786_thumb.jpg

 

First time i've booted with -v -f flags only. Then tryed npci=0x2000.

Link to comment
Share on other sites

why you use iMac 8,1 smbios? if you have a Laptop, post your Extra folder and a full report with darwin dumper, use this flag for remove your DSDST., flags= DSDT.aml=\aaaaa

Link to comment
Share on other sites

Recently I installed Chameleon over Clover so I forgot to use old Extra folder from Chameleon. it booted ok without Extra folder at all.

The pictures I sent was from boot empty extra folder + dsdt.aml.

Now I tried to boot with old extra folder from myHack - same result - kp.

Tried to change AppleACPIPlatform.kext from 1.3.5 to 1.7 - same result - kp.

SMBIOS now MBP8.1 - same result - kp.

With DSDT=\aaaaa all boots ok.

 

The reason i trying to make dsdt is my internal lcd has empty edid and i think thats why i cant use patched kexts for 1st gen intel hd graphics. But after i saw comile errors from extracted dsdt i think maybe not only empty edid is the problem.

 

I've attached extra and DarwinDumper report.

 

Thank you for your help iFIRE :)

Extra.zip

DarwinDumper_2.6.5_Chameleon_2.1_ML_root.zip

Link to comment
Share on other sites

ok, a edit a new DSDT for you with minimal patches, put in Extra folder, I look tha you have all kexts in Extra/Extensions, in ML install all kexts in S/L/E, if you have used myHack for install it, all kext that you have in Extra/Extensions are installed in the system in the kext my hack.kext/contents/pluguins take a look in it, and install this AppleAHCI.kext for you hard drive IDE MODE, I edit it with correct device id of your hardware.

 

 

DSDT and kext.zip

Link to comment
Share on other sites

My internal hard drive is out of work now nad IDE mode is for recovery software. I run my ML system from external usb HDD.

I'm sorry if i waste your time for that ide mode kext

 

Ok. I tried new dsdt. Same situation.

Tried cpus=1; npci=0x2000 or 0x3000;

tried change AppleACPIPlatform.kext to 1.3.5 from my hack and for original 1.7. Same kp.

With cpus=1 it turned off after that message.

 

I didn't know if i need to use attached kext since i dont use my internal hdd so i botted in ahci mode without kext.

Link to comment
Share on other sites

I sugest for you that update your bios for the last version and Extract a new DSDT, or don´t use a DSDT,

 

EDIT. You have update your boot loader for the lasted version?

Link to comment
Share on other sites

 Share

×
×
  • Create New...