Jump to content

Help HIS ATI Radeon HD5670 ICEQ Redwood XT not working in ML 10.8.3


catalinz
 Share

3 posts in this topic

Recommended Posts

Hello All!

 

I need some help, I seem to get very stuck with the video card not loading right kexts i think.

Also i have read that my video card will work fine in hackingtosh, here are my full specs:

i7-2600K SandyBridge, 3400Mhz, 8MB on Asus P8Z68-V PRO, socket 1155

Video HIS ATI HD5670 ICEQ Redwood XT, 1024MB, 128bit, GDDR5, PCI-E on Monitor Samsung S27A950D 27′ / 1080p Full HD, 3D, 120mhz DP, HDMI, DVI

SSD Corsair ForceGT 90GB, SATA3 and HDD Western DIgital 1TB, 7200RPM, 64MB, SATA3

Kit Dual Channel Corsair 8GB (2 x 4GB), DDR3, 1333MHZ, Radiator

 

I installed ML 10.8.3, all went smooth, with no bios changes only limit cpuid disabled, also i booted straight-up without the need of -v or -npci command, worked straight!

 

But it seems, either on displayport, hdmi, or dvi, i can`t get higher than 1400×1050 resolution, thus i normaly use my monitor on Windows8 connected to the displayport 1920 x 1080 @ 120mhz.

In chameleon boot.plist i have checked Ati enabler, Ati config, selected Baboon, 3 ports, Use Atirom, and resolution 1920×1080, didnt work.

Ieven extracted with gpuz the bios from the video card, and changed with the right id (PCI Device 1002-68D8 / 1787-200B (Rev 00)) and put it in the extra folder doesn`t work also icon_neutral.gif?m=1129645325g

 

Dont know what to do more, i didnt want to bother asking for help, but it seems a dead end for me.

Also you can check here, go to the midlle of the page http://www.insanelym... p8z68__st__360 (i also opened thread here as the OP of the guide adviced) to see what things i tried for the video to get it worked and my results, maybe they can help to identify my problem.

 

Here is also my vbios:

Redwood.zip

 

Thanks in advance!

Link to comment
Share on other sites

 Share

×
×
  • Create New...