Jump to content

Help, Quadro FX1500M


Fragrance89
 Share

2 posts in this topic

Recommended Posts

Hi everyone!

I am a bit confused about how to make this graphic card work, because I have tried almost every single kext for Nvidia and nothing turned out to be effective.

I'm using iAtkos S3 v2 and it works fine except the GPU. If I select the original NVinject/NVenabler from the DVD installer with or without GraphicsEnabler=Yes it shows a full resolution Blue or Black screen which fades from light to dark blue. It seems that the full resolution of 1920x1200 is recognized but there is no image. I was able to make this card - Nvidia Quadro FX 1500m 512MB GDDR3 fully working with QE/CI on Leopard 10.5.2 with Kalyway DVD and NVinject512 for laptops. I don't use Kalyway anymore because almost nothing works except the GPU while on iAtkos 10.6.3 only the GPU doesn't.

I'm pretty sure that we will make it work, it's only a matter of time. However, if I do not select any enabler/ injector during or after the installation, OS X boots ok and I can use it, bit I am stuck at 1024x768 and it shows only 256mb instead of 512mb of memory. Where could be the problem?

P.S. If I use NVinject/NVenabler and boot with -v -x cpus=1 GraphicsEnabler=Yes, OS X boots properly at full resolution and recognizes the card (Name,BIOS version,the entire amount of memory, everything) but it is in safe mode so no QE/CI. Strange, right!

Best regards!

Martin

Link to comment
Share on other sites

 Share

×
×
  • Create New...