myran2 Posted September 11, 2011 Share Posted September 11, 2011 After researching a bit online before starting, I've found that it's impossible to boot from a drive with a GUID partition on any Lenovo laptop. So, I spent my time going 10.6.3 -> 10.6.8 on a GUID partition table using the [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] 3 CD. I finally got 10.6.8 installed, so I "restored" it to a flashdrive, then reformatted my laptop's drive to MBR. Then I "restored" the flash drive backup to the newly MBR formatted laptop drive. This should leave me with a working 10.6.8 install that should be bootable with an [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] CD. Unfortunately, booting from the HDD results in this: boot0: testing boot0: error What did I do wrong? I've looked around and I'm pretty sure my OSX partition is set to active. I have tried install Chimera 1.5.4 and 1.4.1, both have resulted in the same issue. Is there something I'm missing? Link to comment Share on other sites More sharing options...
Recommended Posts