Sword7 Posted July 15, 2011 Share Posted July 15, 2011 (edited) Hello folks, I tried to install OS X Snow Leopard system into my external 750 GB eSATA drive because primary 160 GB hard drive is full. I got [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] v3.1 CD from other site but it can see eSATA drive during boot time but OS X system can't see eSATA drive with JMB 36x kext installed. It recognizes that JMicron 360 chip but can't see eSATA drive upon boot complete. Also, I tried to install it with USB hard drive but it kept got instant reboots before reaching Chameleon menu. However, I can only boot it with USB thumb drive. I think that it is a bug in BIOS v300 firmware that cause instant reboots because I was able boot the same USB hard drive on my desktop normally. Does anyone have any good solutions with external bootable eSATA drive and USB hard drive? Thanks, Sword7 Edited July 15, 2011 by Sword7 Link to comment Share on other sites More sharing options...
Recommended Posts