Jump to content

How do i solve kernel panic?


asaoifsa
 Share

1 post in this topic

Recommended Posts

I'm new to all this osx86 project and i could use a little help..

so i prepared the snow leopard install disk on a friends mac, and replaced osinstall.mpkg in a couple of locations in order to boot.

i used [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] after the the boot132-method failed, chosen the mac osx install dvd and got the kernel panic attached

 

i'm starting to doubt that the panic is because my HDD is connected through an ide interface with the pins and stuff, and not a sata connection (is that relevant) and i read that AHCI must be enabled which is not possible on native ide. could this be the reason behind all my worries?

 

my rig specifications

 

amd athlon le-1640

kingston ddr2 value ram 800mhz

gigabyte MA74GM-S2

ati radeon 2100 IGP

post-707574-1293196544_thumb.jpg

post-707574-1293196704_thumb.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...