Help installing iAtkos s3 v2, hd sata not recognized

[calamaro]

Hi to all, i'm new of this forum, i'm writing because i've a problem with iAtkos s3 v2 distro installation, the boot is ok and the initial setup too, but when appear the hard disk selection window, the software doesn't show any hard disk. Could you help me? Why doesn't show my sata hd?

 

My config:

 

MB: MSI MS-7387

Processor: Intel core 2 Duo 2.0 ghz

HD: 500 GB sata Seagate

 

Thanks to all

[Anonomys1991]

in the bios find device configuration or perihperal settings look for SATA NATIVE MODE or SATA MODE

 

if you have SATA NATIVE MODE then make sure it is enabled this sets it into AHCI MODE

 

if you have SATA mode make sure it is in AHCI MODE

[calamaro]

in the bios find device configuration or perihperal settings look for SATA NATIVE MODE or SATA MODE

 

if you have SATA NATIVE MODE then make sure it is enabled this sets it into AHCI MODE

 

if you have SATA mode make sure it is in AHCI MODE

 

I haven't SATA NATIVE MODE or SATA MODE options in my bios. I can't find AHCI option.

What can i do?

 

Thanks