Jump to content

Finally enabled QE Nvidia Geforce 7300 10.6.3 + 10.6.4


hkarir
 Share

1 post in this topic

Recommended Posts

After a full week of messing around and doing EVERYTHING I could to enable QE for my Nvidia Geforce 7300 Go graphics card, I finally did it easily!

 

 

I am a total noob and don’t have a CLUE about Mac until 1 week ago! So if I can do it anyone can!

 

 

I installed loads of {censored} edited strings, Nvida stuff and all sorts but nothing worked. I done every single thing possible until today I come across tonymacx86 blog!

 

 

I had already installed MAC OSX 10.6.3 and all I did was install MAC OSX 10.6.4 update and in [url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url] installed Nvidia just that (was not specific to a particular Nvidia graphics card).

 

 

Rebooted and now I can use imoves and QE is enabled.

 

 

Mac OS X 10.6.4 Combo Update

 

[url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]

 

 

The instructions are on this website: http://tonymacx86.blogspot.com/2010/04/[url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]-[url="http://www.insanelymac.com/forum/topic/279450-why-insanelymac-does-not-support-tonymacx86/"]#####[/url]-install-mac-os-x-on.html

 

 

I hope this helps all the Nvida dudes out there, I have seen 100’s of post that you can’t enable QE on your graphic card! This will do it.

Link to comment
Share on other sites

 Share

×
×
  • Create New...