3 replies to this topic

[hnak]

I recently got a  PCI Express Gigabit NIC based on Agere ( LSI Logic ) et1310.
I found  a Linux driver ( not so new ) and ported  to 10.5/10.6.

2012-06-02: Just enabled VLAN ( not accelerated by hardware ).
1.2.3a

Binary & Source ( including original Linux driver )
1.0.0

[swiftprince]

hnak, on Apr 13 2010, 01:25 PM, said:

I recently got a  PCI Express Gigabit NIC based on Agere ( LSI Logic ) et1310.
I found  a Linux driver ( not so new ) and ported  to 10.5/10.6.

Binary & Source ( including original Linux driver )
1.0.0

Thank you hnak,

I've got a LGR200 notebook with the agere 131x and after installing your kext it works flawlessly....
Thank you again and good work. I've got my MacOSX running @ 95%... only if I could find a decent driver for my Wireless.... so... I'm still looking for it.

[Darnei Tiger]

hnak, on Apr 13 2010, 08:25 AM, said:

I recently got a  PCI Express Gigabit NIC based on Agere ( LSI Logic ) et1310.
I found  a Linux driver ( not so new ) and ported  to 10.5/10.6.

Binary & Source ( including original Linux driver )
1.0.0

I just wanted to say thank you.  I have been hunting high and low for years for a driver that would work for my onboard gigabit.  I loaded up your kext, didnt even need to restart the system, and it works like a dream.  thankyouthankyou

[hnak]

I recently modified getFeature() entry of some drivers to return kIONetworkFeatureHardwareVlan. Then I tried with this kext ( the chip does not support hardware acceleration ) to return kIONetworkFeatureSoftwareVlan and found that VLAN works. So I update the download link. There is no difference other than VLAN.