Chameleon locking up on 945g7ma

[jesus911]

Having problems with my SnowLeopard install locking up just befor it boots into verbose mode. I can successfully load Chameleon RC3 and select the usb drive with the .dmg on it. After selecting the disk it then loads all the kext files. After this it waits for me to press anykey to boot into darwin. I do so and then it just sits on a black screen. I am not sure if this is becuse dsdt.aml is configure incorrectly, or if i have am missing a .kext file? possibly a kext that needs to be removed? ill attach my dsdt.aml and .hex file are attached. I have aslo had a problem on previous attempt, not sure if they are related. Had one install boot all the way up to the grey apple screen and freeze at that point. Any suggestions are much appricated. thx

 

My hardware set up is as follows:

 

Motherboard: Foxxcon 945g7ma

 

Processor: 2.8 Pentium D

 

Ram: OCZ DDR2 800mhz Reaper

 

Hard Drives= 1x120 maxtor (soon to be my sl drive)

 

3x500gig wd dont kno the model of by hand (windows drives)

dsdt.zip