Jump to content

Chameleon causes infinite loop of resets.


1 post in this topic

Recommended Posts

I looked around for a little while and found nothing on how to fix it, so I figured I'd ask.

 

Alright, so I managed to get OS X and Windows XP both installed on my laptop. I am wanting to use JUST the Windows XP boot loader. I have it set up as the first thing I see after POST, and when I click Windows XP, it boot directly into XP no problem. However, when I click on Mac OS X, it opens Chameleon 2, than the bar goes down to the end, and the white apple loading screen pops up for a split second, than the computer reboots. How can I make the OS X option boot directly into OS X? I have tried Chameleon 1 & 2, as well as the other one on the iATKOS disc(I can't remember the name ATM...)

 

If I put in my iATKOS v7 disc, than press F8, than type in rd=disk0s1, it loads OS X just fine, so I know it is there.

 

Any information I think you may need is below. If you need more, please ask.

 

Hard Drive Setup: 25 GB Partition for OS X on disk0s1, 50 GB partition for XP on disk0s2.

Installation disc: iATKOS v7

Computer: Gateway 7422GX

Motherboard Name: 7400 Series

North Bridge: VIA VT8385 Apollo K8T800M

North Bridge: AMD Hammer IMC

South Brideg: VIA VT8235

Processor: AMD 3400+

Link to comment
Share on other sites

 Share

×
×
  • Create New...