vwbus Posted September 20, 2009 Share Posted September 20, 2009 I have successfully installed SL on my GA-EP35-DS3L using the BlackOSX guide. I have a few post install issues, but this one has me perplexed. When I boot to my 10.5.7 partition all of my firewire devices are available and work with no issues whatsoever. However, in 10.6.1 I can't see them at all. I'm not sure where to begin to see what the deal is. So where do I start? Thanks for all of the wonderful work you all do. vwbus Link to comment Share on other sites More sharing options...
doradekell Posted September 21, 2009 Share Posted September 21, 2009 I have successfully installed SL on my GA-EP35-DS3L using the BlackOSX guide. I have a few post install issues, but this one has me perplexed. When I boot to my 10.5.7 partition all of my firewire devices are available and work with no issues whatsoever. However, in 10.6.1 I can't see them at all. I'm not sure where to begin to see what the deal is. So where do I start? Thanks for all of the wonderful work you all do. vwbus I had the same issue that you did. I simply pulled mine out and put it in a different PCI slot. Next reboot and it was back. Dora Link to comment Share on other sites More sharing options...
vwbus Posted September 21, 2009 Author Share Posted September 21, 2009 I had the same issue that you did. I simply pulled mine out and put it in a different PCI slot. Next reboot and it was back. Dora That worked! Link to comment Share on other sites More sharing options...
Recommended Posts