Jump to content

Dual boot: Win+Mac, but Darwin don't want boot!


LaGuNa
 Share

5 posts in this topic

Recommended Posts

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.

Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

Link to comment
Share on other sites

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.

Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

Maybe your computer doesn't have SSE2?

thats the minimum for osx86

Link to comment
Share on other sites

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.

Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

 

Darwin bootloader has some problems with extended partitions ;)

 

choose "Mac x86" , press Enter and then quickly F8. select your mac partition and press Enter again.

 

gl&hf

Link to comment
Share on other sites

Yeeeeeeeesssssssssssssssssssss!!! Tiger now works so fine!!!

Thanks soooooooo muuuuuuuuuch daGriech!!! :poster_oops:

But, can I set the second partition as the default partition for Darwin at boot??!? It's so boring press F8 each time... :-P

Link to comment
Share on other sites

 Share

×
×
  • Create New...